Application
Instructions for use • C-MAC Monitor • NDQ566_EN_V1.0_02-2021_IFU_CE-MDR
25
Certain functions can also be controlled via the camera. The following requirements must be
met:
–
The camera has control buttons
–
The control buttons on the camera are enabled
The menu consists of levels 1 to 10. Pressing the control button next to the
Next level
symbol
accesses the functions one level down.
Level 1
Video recording
Starts the video recording and saves the recording to the SD card.
The
video recording
symbol appears in the top left-hand corner of the live image.
The function symbol next to the control button changes to
Stop video recording
.
If the
video recording
symbol is grayed out, video recording is not possible.
Stop video recording
Stops the video recording.
Video recording stops automatically under the following conditions:
–
The battery is empty
–
The SD card is full
–
The device has been switched to standby
–
The recording is taking longer than one hour
Still image capture
Saves the live image on the screen to the SD card.
If the
Still image capture
symbol is not visible or is grayed out, still image cap-
ture is not possible.
Freeze with single image capture
Freezes the live image on the screen and saves the live image to the SD card.
Pressing any control button stops the
Freeze
function.
Freeze without still image capture
Freezes the live image on the screen.
Pressing any control button stops the
Freeze
function.
Change camera unit
The
Change camera unit
symbol is visible only if two camera units are con-
nected to the C-MAC monitor at the same time.
Switches between the two connected camera units.
