INsTaLLaTION INsTRUCTIONs - eLeCTRIC
Whilst every care is taken to eliminate
burrs and raw edges from this product,
please take care when handling - we
recommend the use of protective gloves
during installation.
Moving the cooker
Please note that the weight of this appli-
ance is approximately
60kg
(unpacked).
take care if the appli ance needs to be
lifted during installation - always use an
appropriate method of lifting.
Do not attempt to move the cooker by
pulling on the doors or handles. open the
door and grasp the frame of the cooker,
taking care that the door does not shut
on your fingers.
take care to avoid damage to soft or
uneven floor coverings when moving the
appliance. Some cush ioned vinyl floor
coverings may not be designed to with-
stand sliding appliances without marking
or damage.
Important
: Ensure that you route all
mains cables well clear of any adjacent
heat source.
Clearances
This cooker may be fitted flush to base
units. However, for models with side
opening doors, we recommend a side
clearance of 60mm between the cooker
and any side wall to allow the door to be
opened fully.
the cooker should not be placed on a
base.
no shelf or overhang or cooker hood shall
be closer than a minimum of 650mm, but
check with cooker hood manufacturer’s
recommendations.
the cooker must have a side clearance
above hob level of 90mm up to a height
of 400mm.
Dimensions
All sizes are nominal, and some varia-
tion is to be expected. the ‘depth’ of the
cooker, as given below, is to the front
of the door and excluding knobs and
handles.
Depth:
600mm
Width:
500 / 550 / 600mm
Height (adjustable): 900 - 915mm
Levelling the cooker
there are four adjustable feet on the
base of the cooker. turn the feet by hand
to adjust the height of the cooker.