Installation Instructions
25
Method 1:
Without housing unit
(between 2 base units)
Before installing the appliance, check
the internal dimensions as shown.
The space for the appliance must be
clear of obstruction. You may have to
cut into or remove any rear cross
members to obtain the 550mm min-
imum depth.
The Fixing Kit
Should you need a replacement fixing
kit please call:
0870 458 9961
and order part
number:
01 28287 00
.
In the fixing kit you will find 2 side
trims (687mm long) and 4 runners
(420mm long). The fixing screws are
in a polythene bag in the oven.
1. Take the 6 No 8 x 12mm (silver)
self tapping screws from the
polythene bag, and use them to fit
one runner to each side of the
appliance.
2. Make sure they are the right way
up as shown.
3. Take one of the side trims, hold it
against the side of the base unit,
and mark off 687mm from the top
edge of the base unit, to the top
edge of the runner.
Note:
This ensures a 5 - 8mm
clearance from the underside of the
worktop to the top of the appliance.
4. Measure 50mm from the front
edge of the base units, to mark the
front edge of the runners.
5. Take 6 of the No 8 x 12mm
(Black) chipboard screws and
screw the runners into opposition
the right way up as shown.
6. Fit the side trims to be flush to the
top and front edges of the base units,
using the remaining 6 No 8 x
12mm (Black) chipboard screws.
08 27348 00 - Howdens 70FP 25/4/07 7:43 Page 27