Installation Instructions
Installing the hob above an oven
In the even of repeated operation of the thermal protec-
tion devices, you can install an insulation kit between
the oven and the hob (available from Stoves Customer
Support or your local supplier).
With this configuration, the oven can be fitted in the
unit in the lower position only.
Installing the hob above a Stoves 600mm single
cavity oven
A minimum 9mm gap must be maintained between the
oven top and the base of the hotplate.
Installing the hob above a Stoves 720mm twin
cavity oven
A minimum 9mm gap must be maintained between the
oven top and the base of the hotplate.
The appliance MUST be fitted on the runner kit provid-
ed. It is not suitable for shelf type installation if the
plinth line is to be maintained.
Ovens other than Stoves
Refer to the manufacturer’s instructions for clearances
above the oven.
We recommend a 9mm gap between hob and appliance,
should the work surface be less than 38mm deep.
Installing the hob above a pyrolytic oven
If installing the hob above a pyrolytic oven, additional
provision for air c i rculation / ve n t ilation may be re q u i re d .
Due to the exc e s s i ve tempera t u res attained during py ro l y-
sis, using the hob at the same time may cause the thermal
s a fe ty device within the hob to operate.
21
08 26296 00 - C TCi 22/10/07 10:07 am Page 21
Summary of Contents for S7-C600TCi
Page 1: ...S7 C600TCi S7 C900TCi Handbook ...
Page 26: ......