6
Install the joystick
Step 1
Mount the joystick in the tube under the
armrest and tighten the screw in the
desired position.
Step 2
Assemble the cable connectors and
gently rotate until the pins enter the
holes and the grooves in the two
connectors engage. Then screw the
sleeves together on each contact.
IMPORTANT!
Be careful not to
damageor bend the
pins in the connector.
IMPORTANT!
NEVER connect
the charger directly
to the battery.
This is how you charge
Start by turning off your Eloflex (all lights
on the joystick should be off). Connect
the charger to the socket on the front
of the joystick. Make sure that the
contacts’ position matches each other.
Then plug the charger’s power cable
into a wall outlet.
Charging is indicated by a lamp on the
charger. Red lamp means that charging
is in progress. After about three
hours, the batteries are charged at 90
percent. The chair can now be used
again.
After about 5-8 hours, the light on the
charger becomes green and the batte-
ries are fully charged. During charging,
the charger itself becomes warm, and
this is normal. For maximum battery life,
charging. Charging instructions should
take place for about five hours when
Charging instructions
the bar on the battery indicator at the
joystick has dropped to one third (when
three of the lights are green).
The batteries will not be damaged by
maintenance charges but for maximum
battery lifespan we recommend that
you disconnect the charger when the
batteries are fully charged. Charging
the batteries can be done
down to -10 degrees. When charging
in lower temperatures, the batteries will
not get fully charged.
If your Eloflex is used in minus degrees,
the mileage is affected. For example,
at -10 degrees, the mileage can be
reduced by up to 50 %.
F
P
D2
L
H
X
F
P
D2
L
H
X
