Brown
Green
White
Electrical Connections
Min. Value
Standard
Value
Max Value
Power supply
AC
DC
-10%
-10%
12-24
12-24
+10%
+15%
mA
22
35
Standby power consumption
Peak power consumption (1 sec)
Holding current
Current draw in “hold open” mode
Opening time settings
mA
mA (dc)
mA(dc)
sec
160
1100
130
12
1200
20
Technical documentation
1) The trimmer enables the handle opening and closing time to be set from a minimum of 3 to a max 30 secsonds,
gently turn anticlockwise with a small screwdriver to reduce the time and clockwise to increase it.
2) Each time the lever is operated, the device switches back to idle irrespective of the set opening time.
3) If the handle recives an opening pulse while the lever is lowered, this pulse will be memorised for a certain
period of time and when the lever is released the handle will be activated without there being any need for an
additional opening pulse.
4)The electric pulse for activating the device can be given either via a pushbutton or a switch. In the latter case
about 1 min after the switch is turned on the handle will go into the “HOLD OPEN” mode (doggin mechanism),
that is it will remain in an activated state untill the switch is turned off.
The changeover into the “HOLD OPEN” mode is confirmed by a faster blinking of the LED compared to the
conventional mode. A typical situation is to have a push button and switch connected in parallel: with this configuration
the user can decide whether to operate withthe push button (single passge) or set it to remain activated for as long as
the switch is left on. The switch can be replaced with an external programmer or any other device that the user judges
most appropiate,
INSTALLATION NOTES:
It is advisable to use a cable gland to avoid damage to the electronic components.
PH381 Inst 051218
NOTE
This product is not IP rated
