issue V8.3E from
01.07.2019
7
The threaded hole at the foot of
the support arm must match the
lower threaded hole of the
clamping device.
Turn in the grub screw (M6x10)
flush with the exterior of
the clamping device.
Do not tighten the screw!
When correctly assembled,
the support arm can be
rotated easily
but
cannot be pulled out.
Note: The arm should be moveable without blockade by
pin 1
.
Together with the pressed foot of the arm by
pin 2
results a swiveling unit
with excerpt protection.
3.1.1 Connecting the patient cables to the ECG device
Only CE marked devices may be connected
(see also operating instructions ECG)
3.2
Connect the vacuum unit
plug in
vacuum hose
plug in
power cable
(If you want to remove the vacuum hose,
push back the ring of the vacuum hose
elbow connector, in order to pull off the
hose. )
bottom of the device bottom of the device
For a secure fixing in mobile
operation we recommend
replacing the stands with a
Velcro tape fixation. Stands and
Velcro tape are adhesive und
thus easily replaceable without
tools.
1
2
Tighten the upper grub screw (M6x6)
so that
the foot of the support arm
presses firmly against the clamping
device.
[example]
