ofdevice, please contact the after-sales service center.
2. Can’t recognize TF card. Please make sure the following points about TF card:
①
Using TF card with good quality
②
TF card
＜
32G.
4. WiFi Signal is weak. Make sure WiFi signal source is within the range of 20 meters and there is not
too much barriers (Note: The wall could reduce WiFi signal a lot),and make sure your hands don’t
cover the wire housing in the back panel.
5. Touch doesn’t work appropriately. Make sure the fingers away from the touching field while holding
the device.
6. Image can’t rotate with the direction of device. Check “setting” to see if “Auto Rotation” is canceled.
7. Crash. While operating some low-quality software in the device, the system will crash. Just need to
Unplug the power cable, and the device will be forced to shut down.
13. The boot is too slow. In the common situation, the boot takes about 30 seconds.But if the device
has unexpected shutdown like crash, it will take much longer time to boot the device.
Please see the actual product for knowing more detailed function.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired
operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF
warning
for
Mobile
device:
This
equipment
complies
with
FCC
radiation
exposure
limits
set
forth
for
an
uncontrolled
environment.
This
equipment
should
be
installed
and
operated
with
minimum
distance
20cm
between
the
radiator
&
your
body.
