2. Fuselage:
Take the M2 couplers, glue them with CA onto the glasfibre pushrods and screw the plastic ball links on it. Push the
these pushrods from the backside into to preinstalled pushrod sleeve. The small fuselage cover fill be fixed with
tape.
Depending on used servos make/mill openings for them (see picture above). Screw M2 metal clevises with M2
couplers. Cut glas fibre pushrod that it fits for servoarm and glue M2 couplers with pushrod (use some CA).
Make now cable-connection for wingservos. For that solder servocables with 6-pol MPX connector (male part).
Battery for receiver should be positioned as in picture above. For balancing the model you need some ballast in the
nose. You can use some small Pb balls and fix them afterwards with resin or you fill melt Pb into the nose. For that
you have to put the nose into cold water for cooling.
3. Recommended accessories:
Wingservos: Volz Wing Maxx, Hitec HS-5125MG, Futaba S3150
Fuselageservos: Graupner DS368, Hitec HS-85MG, Hitec HS-5125MG
Receiver: Octava MZK, Graupner SMC 16,...
Battery: 4xAA-Zellen (Sanyo 2700mAh)
Ballast: 10-pcs. brass = 1020g STRATAIR
Wingbags: wing + tail STRATAIR
Summary of Contents for F3B
Page 4: ...6 Technische Daten ...
