DOC-01207 Rev. A
Page 7
For More Information
1 Introduction
This
document
provides
site
‐
preparation
information
and
requirements
for
the
WaterJet
system,
to
ensure
proper
installation
and
operation.
The
customer
is
responsible
for
preparing
the
installation
site
according
to
the
instructions
and
guidelines
described
in
this
document.
The
following
topics
are
covered
in
this
guide:
• Physical
description
• Site
requirements
1.1 For More Information
For
special
operating
conditions,
or
if
you
have
any
questions
about
the
site
preparation
procedure,
contact
your
Stratasys
representative.
Visit
http://www.stratasys.com
for
more
details
about
Stratasys,
its
technology,
products
and
consumables,
and
for
application
information.
If
you
have
any
questions
about
the
information
presented
in
this
document,
or
if
you
have
any
comments
or
suggestions
for
future
editions,
please
send
a
message
to
c
‐
support@stratasys.com.
1.2 Terms Used in This Guide
Important:
Since preparation of the site must be completed before the installation date, you must fax
the checklist at the end of this document to your local Stratasys representative after
carrying out the tasks described in this guide. After the checklist is reviewed, a date will
be set for installation.
Resin
The
base
substance
from
which
photopolymer
materials
are
made
for
use
in
Stratasys
polyjet
printers.
Model
material
Material
used
for
building
models.
Support
material
Material
used
for
supporting
the
structure
of
models
during
production.
