©
Drechselbedarf Schulte
- 14 -
Translation of the Original Instruction Manual Version 1.0
Attach the prepared timber board (use the drilling template Appendix 4) to the fixing points (see Fig. 14)
on the left stand for the outrigger using the supplied 3/8“ bolts. Then align the stand in such a way that it
is flush with the board and secure the board on the right stand using a bar clamp.
Fig. 14
Before fixing the lathe bed to the stand, reduce the weight of the lathe bed. Remove the plastic cover,
headstock, tailstock, and tool rest support. To do this, loosen the stops on both ends of the lathe bed
(Fig. 16) and watch out for the connected cables.
Using two people, lift the headstock
from the lathe bed guide and place it
on two timber bearers next to the lathe
between the stands (Fig. 17 + 18).
Advice: Lock the spindle in place and
insert a 12 mm bar into the hollow
spindle for easier transport.
Make sure that cables do not get
damaged.
Using two people, lift the empty lathe
bed (Fig. 19) onto the stand and align
it.
Fig. 15 Lathe bed with headstock, tool rest and tailstock
Fig. 16 Removing the stop rod
A
Summary of Contents for FU-230
Page 1: ...FU 230 WOOD TURNING LATHE...
