To install the feet, ensure the engraved line on the bottom of both feet is facing outwards, then
secure them to the main body using the M3 thumbscrews from the top and through the enlarged
circular holes.
Make sure the thumbscrews are properly tightened and if necessary use a screwdriver as this is
critical for a stable platform.
Fitting the feet and PSU
With the feet secured, it is now possible to fit the PSU which attaches directly to the right side foot
under the table. Only 3 thumbscrews are required, but it is important to check if your PSU
requires M3 or 6#32 threaded screws. The BC1 allows for both orientations of the PSU, so it
can be flipped if required, with the fan facing downward.
3
Engraved Line
ATX PSU
