Fit the expansion card to case by carefully aligning it with the opening and
ensuring the lower side of the card bracket fits into the lower support.
Once the cards are in place, secure them to the PCI mount using the
screws provided.
Note that if you face any difficulty in fitting the card, you can also remove
the PCI mount to give a larger opening for the cards to fit. It is held in place
by 2 screws accessible from the inside of the case.
Installing PCI Card (Optional)
The FC10 supports 2 full height expansion cards which can be used for 2
single cards or 1 double width card. The upper slot is limited to 190mm
cards, but the lower slot will allow for 300mm cards. Note that a flexible
riser is required to connect the cards and motherboard. To install a card,
first remove the pre-installed PCI blanking plate by unscrewing it from the
PCI mount.
11
PCI Mount
PH-M3x5
PH-M3x5