Fitting Drives to the Drive Tray
The upper side of the drive tray can accommodated a maximum of 4 x 2.5" hard drives (3 x 2.5" for the Optical Version) and also uses slots which allow the drives to
mounted anywhere along the tray. The 2.5" drives are secured in place by 4 screws per drive, screwed from the bottom of the tray. These 2.5" should be fitted
prior to installing the lower 3.5" drives.
The lower side of the drive tray can accommodate a maximum of 2 x 3.5" hard drives and also uses slots instead of fixed holes, to allow drives to be fitted anywhere
along the tray and with different orientations. The drives are secured to the tray using thumbscrews which fit through the slots and into the side holes of the hard
drives.
If you have the OPTICAL version of the FC10, secure the optical drive to the drive tray with the 4 screws as shown, but DO NOT fully tighten the screws. Only
after you have closed the drive tray back into the case should these screws be tightened as you will need to adjust the position of the drive to line up with the front of
the case.
Optical Drive Assembly
2.5" Drive
3.5" Drive
13
TC-M3x3
TS-6#32
TC-M3x4
