Page
2 .................
3 .................
4 .................
5 - 6 ...........
7 - 8 ...........
9 .................
10 ..............
11 .............
12 - 13 ..........
14 ..............
15 ..............
Contents
Index, Message, Introduction
Product Overview
Preparation for Assembly
Installing the Motherboard
Installing the CPU Cooler
Installing PSU & Other Accessories
Wiring Diagram
Installing Expansion Card (Optional)
Installing Drives
Replacing the Drive Tray
Replacing the Top Panel
A Message from the Streacom Team
IMPORTANT NOTICE
Passively cooled products can get hot to the touch, especially when systems are
running at high loads for extended periods. This is a normal part of their operation and
they have been tested to run safely under these conditions. Please take their
operational temperature into consideration when positioning and handling.
Introduction to Assembling Your Case
It’s not rocket science, but Streacom cases can be a little challenging to assemble at first because of the non traditional design and the materials used. Passive cooled
cases have an added layer of complexity because of the heatpipe assembly/hardware requirements, so please take the time to read the user guide and become
familiar with the components and assembly procedure. Additional information is also available on our website ‘system build guide’ page, and of course from our
support staff.
Below is a quick explanation of the different screws used in the assembly, and how they will be referred to throughout the guide. Screws are defined by head type,
e.g. ‘countersunk’ and by thread/size e.g. M3x5, and will be labeled with all that information, e.g. CS-M3x5
Thank you for choosing Streacom! In a market dominated by generic and uninspired products, we are on a mission to break the mold, not only of design, but
materials and finish. This is a value that is not easily conveyed in an industry preoccupied with specs and numbers, so your choice shows an appreciation and
understanding of what makes our products different, and we sincerely thank you for that.
Every care has been taken to ensure that this product meets the highest quality and standards we have defined. If anything about this product falls short of
your expectations or you have any questions that are not covered in this user guide, please contact us online at www.streacom.com/contact. We respond to
every question received and your feedback is a critical part of our ongoing product development and refinement.
From everyone at Streacom, we hope that you enjoy using our product!
COPYRIGHT NOTICE
Copyright © 2014 Streacom. All Rights Reserved. No part of this publication may be
reproduced, stored in a retrieval system, or transmitted, in any form or in any means –
by electronic, mechanical, photocopying, recording or otherwise – without prior
written permission. All trademarks and registered trademarks in this publication are the
property of their respective owners. Streacom is a registered trademark.
2
Pan Head Screw (
)
PH
Hex Cheese Head Screw (
)
HC
Countersunk Screw (
)
CS
Thin Cheese Head Screw (
)
TC
PH-M3x5
PH
5mm
3mm
M(Metric)
Thumb Screw (
)
TS
Also included in the kit.....
1 x Lower CPU Mount, 2 x Upper CPU Mount, 3 x Heatsink Connectors,
4 x Heatpipes, 4 x Spring-loaded Screws & Nuts, 1 x Allen Key, 2 x
Thermal Paste Tubes, Silicon Rubber Pads, Double Sided Adhesive Pads.
Tools you will need.....
Philips Screwdriver
