Lisa LCD
34
Enter the service menu and browse until you find the [Upd. SD card] option. Press OK to start the
content update process.
5.8
Manual device activation
The activation process for a Lisa device can be initiated from any of the available command interfaces, by
issuing the respective command. At this stage
will most probably be used.
Command:
getlic
Description
: Start activation process
After the command is issued, the device contacts the activation server and receives the appropriate
code.
G e t l i c e n s e s
[ O K] = S t a r t
It is also possible to activate the device from the Service menu.
The device edition will be shown shortly on the display at startup, while activation results can always be
viewed using
or under “Licenses” option of the service menu.
5.9
Monitoring logging on the platform
If available, the remote monitoring logging on the platform (Device portal, or ADP) is a great source of
information on what happens with the Lisa 'in the field'. The section
information on the conditions under which monitoring is available and how the monitoring logs should be
read.
The basic principle is that the Lisa has two types of log messages:
Periodic log messages that are status updates and that signify that the Lisa still is functioning and
connected to the network
Special log messages that are sent when an event happens, e.g., the device has updated its task
schedule
5.10
LCT logging
When a connection is available between the Lisa and the
constantly sends log messages which are displayed in the monitoring window of LCT. The LCT interface
is the same for all Lisa devices. This monitoring has much greater detail than can be derived from the
remote monitoring (see
).
The logging of LCT can be saved for careful review and may be required by Streamit when providing
support. Please include the LCT log data in support requests when LCT log data is available.
