LUKAS II
User‟s manual
September 2009
Version 1.2
9
EN
GLI
SH
EN
GLI
SH
EN
GLI
SH
U S A
Step 2.1: Country setup
This step is only applicable if [Telephone] was chosen in step
2.0. You will need to select the country where you want to use
the Lukas, from the available list of countries. Use the Menu-
Up/Down buttons to browse the list of available countries. When
your choice is not in the list please contact your dealer. Press
OK button to confirm the choice.
W i t h o u t ’ 0 ’
Step 2.2:
Predial „0‟ setup
This step follows the country setting and also applies only when
[Telephone] was chosen in step 2.0. The two available options
are [With „0‟] and [Without „0‟]. You will need to use the option
[With „0‟] in case the Lukas is used behind a (home-)pabx. In all
other cases the option [Without „0‟] is used. Press OK button to
confirm your choice.
A u t o m o f f
Step 3: E Powering Off setup
This Step is only applicable if [Ethernet] was chosen in step 2.0.
If your choice was [Telephone], please go directly to step 4.
This feature conditions the behaviour of the Lukas device when
the stream it was playing from, stops. By selecting [Autom off],
the Lukas is automatically switched off after the stream is
stopped. When [Manual off] is chosen, the Lukas keeps waiting
for the stream and will only switch off when the On/Off button is
pressed. Press OK button to confirm your choice.
S t r e a m i t
Step 4: Provider setup
This step only will be shown in case there is more than one
providers available and the device is not preconfigured. Choose
your provider (use Menu-Up/Down to browse list of available
providers) and press OK to confirm your choice.
R e m c o o n
Step 5: Remote control setup
This step can be used to enable/disable the IR remote control
the Lukas features. Respectively The option [Remco on], will
enable the remote control, while the option [Remco off] will
disable it. Switching between the two option is possible using
the Menu-Up/Down buttons. Press OK to confirm your choice.
S e t u p r e a d y
Congratulations! You have completed the Lukas startup
configuration wizard. The device will automatically restart and
the wizard settings will be set up as default. On start up your
Lukas
will connect to the selected provider‟s database (Streamit
in this case) and load from there an up to date channel list (and
other settings when available).
If you would like to preconfigure and use the Lukas with other settings, you should use the
Streamit Terminal Program.
During the first connecting of the Lukas with the provider‟s database, most probably the
software of the Lukas will be updated. The progress is shown on the LCD screen. Do NOT power
off the Lukas during software updates, as this can result in not functioning of the Lukas anymore.
