5.4
Switching on your SAS220 device for the first time
Fig. 13: Encoder configurations
5.4
Switching on your SAS220 device for the first time
The first time you switch on your SAS220 device, it will be using its default settings. By default the
SAS220 device will try to connect to the remote web-interface for the configuration update.
When you have already registered your device on the Streamit device portal, the device will get the
correct configurations.
As a second step the device will perform a software update check. Should a newer version be available
from the update server, the SAS220 device will update to this version.
During the download and programming of the new software (also called software
update) it is important that you do not switch off and/or remove the power supply of
your SAS220 device. When you do this, you risk that the device stops functioning. In
case this happens, you can only load new software into the device using STP. Loading
the new software may take up to about 20 seconds.
The device will perform all these actions by itself, no action from you is required.
When the update procedures are finished, the SAS220 is ready to encode and stream.
Depending on the streaming mode, the device will start to listen for incoming connections (Pull by client)
or try to connect to the distribution server (To Icecast2).
Version 1.3
28/10/2015
20 of 21
