5.3
STP (Streamit Terminal Program)
Fig. 10: Telnet screenshot
5.3
STP (Streamit Terminal Program)
STP is a (MS Windows) PC tool that can be used to configure, monitor and update your SAS and other
Streamit devices. STP is free and can be downloaded from the download area of Streamit’s website
(
). Once you have installed STP, you can connect your device using the USB
cable. This will enable the communication with the device.
STP is mainly intended for use during the installation phase. When using STP, the device is connected
to a PC/Laptop via the USB cable. STP is required for the IP configuration of the devices which is not
possible from the web-interface.
5.3.1
When to use STP
STP is mainly intended for used in the following scenarios:
•
During the installation phase, e.g. for the configuration of IP settings or to enable Telnet
•
For low-level monitoring of the operation of devices
•
When it is not possible or not desired to use the other configuration interfaces, e.g. you only require
fixed configuration in the device or you do not have access to the Streamit device portal. For these
scenarios you set the device in the configuration mode ‘I want to use fixed configurations’.
5.3.2
Configuring SAS220 with STP
Make sure that the STP version you are using, supports the SAS220 device. Check for updates from the
Streamit website.
Start with the ‘General settings’ of the device. Choose the Configure tab, then click Device button. This
is also the default view when you start STP.
To configure the ’General settings’ of your device you follow these steps:
•
Select the correct device type (SAS220).
Version 1.3
28/10/2015
17 of 21
