Page 2 of 3
Fit Plug in here
RO Plug
Temporarily remove the small white tube on inlet connection of the RO housing filter housing(See Fig
2), and turn the water supply on, allowing the water to flush through the first three vertical filters for
2-3 minutes, until all visible impurities have disappeared. Turn the water supply off.
Identify the small RO plug which is packaged in the RO
membrane bag. VERY IMPORTANT - Insert this plug into the
notched side of the centre white tube of
the membrane. (See Fig 3) Remove the
white cap on the right hand side of the
horizontal RO housing and insert the blue RO
membrane with the large black rubber seal towards the
open end of the housing. (Fig 4) Screw the end cap of the
membrane housing in place and refit the inlet tube.
Turn the water supply on, and test the system for
leaks. (Allow the system to run for approx. 15 – 20
minutes for the TDS reading to drop to a realistic
figure.)
MAINTENANCE
Replace the three vertical pre filters every 3 months, or sooner in very hard water areas. ()
OPTIONAL EXTRAS
•
Pre R.O. Softening Filter, for use in hard water areas to bring TDS readings down and enhance
R.O. Membrane life. (Part No. FH1K plus fittings)
•
Male Hozelock type fittings kit. (Part No. KIT01300 brass fittings kit or KIT01301 nylon fittings
kit)
•
Post RO resin filter to produce 000ppm from the 300GPD system. (Part No. FH1D plus fittings)
