FILLING tHe WAter tANK
1. Connect a filling hose from a mains water supply to the
port marked ‘Filling Point’ (See Fig 1.)
2. Remove the tank lid to allow the tank to ‘breathe’.
3. Turn on the water supply.
4. When the tank is full the float valve will shut off the
water supply inside the tank.
5. Turn off the tap and replace the tank lid.
6. Disconnect the filling hose from the filling point.
7. Make sure that only clean water is used to fill the tank.
to dISPeNSe WAter
1. Connect the end of the hose, on the hose reel, to the
waterfed pole connector. Unreel sufficient hose required
for the job on hand. Make sure that warning signs are in
place to warn pedestrians of the trip hazard.
2. Switch the pump controller on by pressing the ^
button, (See fig 2) and increase the flow of water to the
pole by holding this button down. To decrease the flow,
press the v button until the desired flow rate is achieved.
The pump should run constantly when it is switched
on. If it is running intermittently, decrease the flow rate.
Failure to do so will result in poor pressure, and may
cause damage to the flow controller or the pump.
3. Clean the surface by brushing in up/down strokes,
paying special attention stubborn marks.
4. Remove the brush from the surface and rinse the surface
using the water jets.
5. When you have completed the cleaning task, switch the
pump off by pressing and holding the third button on
the right, until the system turns off. Depressurize the
pole by squeezing the trigger.
the system must not be
stored under pressure as this will invalidate the warran-
ty.
Disconnect the pole and reel in the extended hose.
