4
W: www.streamline.systems E: sales@streamline.systems T: +44 (0)1626 830 830
W: www.streamline.systems E: sales@streamline.systems T: +44 (0)1626 830 830
5
Maintenance
Transportation
Regular meter readings should be taken using the
enclosed TDS meter to ensure that the system is
producing pure water. When the waters TDS no
longer registers 000ppm, follow the servicing
sequence below.
Make sure that the pump is switched off and that
the system is depressurised by pressing the red
button. Unscrew the bowl of the DI filter, situated
on the back of the trolley, using the filter spanner
which is provided. Remove the spent DI resin
cartridge and replace it with a cartridge filled
with new DI resin. Refit the filter bowl and tighten
it adequately using the spanner. (Remembering
to ensure the rubber seal is in place before
tightening.)
The resin within the cartridge can be refilled by
unscrewing the cap, tipping out the spent resin
and refilling with new resin. Used resin should be
disposed of in a responsible manner. If in doubt
please refer to your local waste collection
service provider.
Remove the container lid and riser tube. Remove
the water container. Loosen the two locking nuts
on either side of the handle and lift and fold the
handle forwards to enable the trolley to fit into a
confined space.
Care should be taken so as to avoid pinching of
the fingers when folding the handle.
Filter Servicing (If fitted with this option)
Changing the Resin
Controller
On/Increase
Pump Speed
Decrease
Pump Speed
Off/Menu
Fill up to the
filling line
Replace
Riser
STREAMLINE®? Warranty
The warranty on all Machines and Equipment is
for 1 year (12-months) from RECORDED DATE
OF PURCHASE.
THIS WARRANTY EXCLUDES NORMAL
MAINTENANCE ITEMS, including but not limited
to HOSES, FILTERS, O-RINGS,
DIAPHRAGMS, VALVES, GASKETS,
CARBON BRUSHES and damage to motors
and other components as a result of failure to
replace normal maintenance items. THIS LIST
IS NOT EXHAUSTIVE.
If
STREAMLINE®
receives notice of such defects
during the warranty period,
STREAMLINE®
will either, at its opinion, repair or replace
components which prove to be defective.
Replacement parts will only be supplied under
warranty, upon the inspection and approval of
the defective parts by
STREAMLINE®
.
Should it be necessary to supply replacement
parts before the opportunity to inspect, these
will be charged at current prices and credit will
only be issued upon subsequent inspection and
warranty approval by
STREAMLINE®
.
The customer is responsible for the cost of
return of the defective part. If warranty is
approved,
STREAMLINE®
will pay for the cost
of the repaired or replacement part.
This warranty excludes the following conditions
and circumstances which are at the discretion
of
STREAMLINE®
:
Wear and tear, misuse, abuse improper
maintenance, frost damage, the use of chemicals
other than those supplied or approved by
STREAMLINE®
, improper installation or repair,
unauthorised modification, incidental or
consequential costs, loss or damage, service,
labour or third party charges, the cost of
returning defective parts to
STREAMLINE®
.
This warranty constitutes the exclusive remedy
of any purchaser of a
STREAMLINE®
unit and
is in lieu of all other warranties, express or
implied, including without limitation any implied
warranty of merchantability or fitness for use, to
the fullest extent permitted by law. In no event
shall any implied warranty of merchantability or
fitness for use exceed the term of the applicable
warranty stated above and
STREAMLINE®
shall
have no other obligation or liability.
Important
Unfortunately these rights cannot be
transferred to a third party.
STREAMFLO
®
