S-CB
+
Boiler Range Manual
8
These instructions are written for the installer of Strebel products and contain all necessary information on the in-
stallation and adjustment of S-CB
+
Ranges of boilers. Please read these instructions fully before installation to en-
sure that all work is carried out correctly.
We suggest that you keep a copy of these instructions near the boiler.
These instructions together with those in any supplemental instruction booklet cover the basic principles to ensure
the satisfactory installation of the boiler, although detail may need slight modification to suit particular local site
conditions.
It is the law that all gas appliances and fittings are installed by a competent person (such as a Gas Safe registered
installer) and in accordance with The Gas Safety (installation and Use) Regulations.
The relevant British standards for installation, codes of practice or rules in force and in accordance with the Manu-
factures’ instructions.
The installation must be carried out in accordance with the following regulations plus relevant codes & standards:
- Due consideration must be given to current Health & Safety Legislation while this product is being installed.
- Key Approved Documents to the Building Regulations, in the region of the United Kingdom that this product is
being installed.
- The Local Building Regulations and Local water by-laws, the gas services area and the Local Authority rec-
ommendations.
- The appropriate British & European Standards for the type of installation and fuel used, including but not ex-
clusively the following standards: -
o
BS 5440: Parts 2 (Flues and Ventilation).
o
BS 6644: Installation of gas-fired hot water boilers of rated inputs between 70kW & 1.8MW
- The clean air act as defined by the local authority.
- The appropriate documents as produced by the Institution of Gas Engineers and Managers Documents
(IGEM) for the type of installation and fuel used, including but not exclusively the following documents: -
o
IGE/UP1
o
IGE/UP2
o
IGE/UP4
o
IGE/UP10
- If the product is being fuelled with LPG then the appropriate UKLPG Codes of Practice (CoP) should be re-
ferred to.
- Wiring to the appliance must be in accordance with the IEE (BS 7671) Wiring Regulations the Health and
Safety Document No 635 “The Electricity at Work Regulations 1989” and any local regulations that apply.
- CP 342: Part 2, 1994. Code of practice for centralised hot water supply
– buildings other than individual dwell-
ings.
- CIBSE, Guides A, B and C.
Adhere to all regulations that are in force at the time of installation or service.
Summary of Contents for S-CB+ Series
