IB-CD10(SL)-WM-E-052605
PRECAUTIONS
9
On Operation
•
If the player is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may condense
on the lens inside the CD player section.
Should this occur, the player will not
operate properly. In this case, remove
the CD and wait about an hour for the
moisture to evaporate.
On Placement
•
Do not leave the player in a location
near a heat source, or in a place subject
to direct sunlight, excessive dust or
mechanical shock.
•
Do not place the player on an inclined
or unstable place.
•
Do not place anything within 1 inch of the
back of the cabinet. The ventilation holes
must not be covered for the player to
operate properly and prolong the life of
its components.
•
If the player is left in a car parked in the
sun, be sure to choose a location in the
car where the player will not be subjected
to the direct rays of the sun.
•
Since a strong magnet is used for the
speakers, keep personal credit cards
using magnetic coding or springwound
watches away from the player to prevent
possible damage from the magnets.
On Safety
•
As the laser beam used in the CD player
section may be harmful to the eyes, do
not attempt to disassemble the cabinet.
Refer servicing to qualified personnel only.
•
Should any solid object or liquid fall into
the player, unplug the player, and have it
checked by qualified personnel before
operating it any further.
On Power Sources
•
For battery operation, use 6 size
“
C
”
batter ies. We recommend alkaline
batteries for longer life.
•
When the batteries will not be used for a
few weeks or more, remove them to avoid
damage that can be caused by battery
leakage or corrosion.
•
This CD player is designed to be played
on a stable no vibration position. If you
bump the set during CD play, the music
will stop or skip for a few seconds. This
is normal for this type of player.
Notes on CDs
•
Before playing, clean the CD with a
cleaning cloth. Wipe the CD from the
center out.
•
Do not use solvents such as benzine,
thinner, commercially available cleaners
or anti-static spray intended for vinyl LPs.
•
Do not expose the CD to direct sunlight
or heat sources such as hot air ducts,
nor leave it in a car parked in direct
sunlight as there can be a considerable
rise in temperature inside the car.
•
Do not stick paper or stickers on the CD,
nor scratch the CD.
•
After playing, store the CD in its case. If
there is a scratch, dirt or fingerprints on
the CD, it may cause a tracking error or
skipping.
MAINTENANCE
Cleaning the Cabinet
Clean the cabinet, panel and controls with
a soft cloth slightly moistened with a mild
detergent solution. Do not use any type
of abrasive pad, scouring powder, or
solvent, such as alcohol or benzine.
Cleaning the Lens
If the lens becomes dirty, it may cause a
skipping of sound during CD operation.
Clean with a commercially available lens
cleaner and blower.
IB-CD10(SL)-WM-E-050705.pmd
5/26/2005, 9:23 AM
10
