Revised 10/10/2018
ADJUSTING THE ELASTIC STRAPS
Slide the plastic adjusters to tighten or loosen the straps.
USING THE HEADLIGHT
1.
Press the rubber Power Button once to turn on the large T6 LED, pressing again will turn this off and turn on
the two XPE LEDs, pressing again will turn on all three LEDs, pressing a fourth time causes all three LEDs to
flash (
Strobe mode
). Press once more to turn all lights off.
2.
Whenever the headlight is on there will be a red LED light illuminated on battery compartment. This helps to
make you visible to others from the rear and makes it easier to follow the person in front of you who is wearing
the headlight.
NOTE: To extend the battery life we recommend using the two XPE LEDs when full illumination is not necessary.
WARRANTY
Cutting Edge Products, Inc.
extends a One Year Warranty to the
SWET6HL
for the product against defects in materials
or workmanship, with the following exceptions:
1.
The warranty does not cover damage resulting from accident, misuse or abuse, lack of reasonable care, the
affixing of any attachment not provided with the product, loss of parts, or recharging the unit in any manner not in
accordance with the instructions above.
2.
The warranty will be voided if the unit has been opened (with the exception of inserting the batteries according to
the directions above) or tampered with in any way (unless by an Authorized Dealer) or if any unauthorized
replacement parts have been used.
3.
The One Year Warranty extends only to the headlight and LED bulb only. The batteries are excluded from the
warranty because they can be damaged if the charging instructions above are not followed. If you experience any
problem with this unit we recommend first replacing the two 18650 batteries to see if that solves the problem.
CONDITIONS OF SALE
Purchase of this product is an agreement by the purchaser/user to hold all sellers and manufacturers harmless of all
liabilities and damages.
TO OBTAIN SERVICE
Contact the Authorized Dealer from whom you purchased this unit for Return Merchandise Authorization (RMA). The
return unit must be sent postage prepaid and proof of purchase is required. Damage or loss occurring during shipment
is not covered by this warranty.
