This document contains proprietary and copyrighted information subject to change without notice. The information in this
document shall not be duplicated, used, or disclosed in whole or in part outside of MAI Media Group © 2015. Any distribution
of this material without the written consent of MAI Media Group is strictly prohibited.
- Clean the area on the windshield where the unit will be installed with a glass cleaning
solution such as Windex or rubbing alcohol.
- For positioning the unit, it is better to place the unit closer to the center of the vehicle. If
the unit is installed on the right or left side of the rear view mirror, ensure there is room to
detach the unit if needed via the sliding bracket. Also check that the installation does not
affect normal viewing angle adjustment for the rear view mirror.
- The adhesive on the bracket is very strong. Partially remove the cover of the adhesive
area and then use the full adhesive surface area for final installation.
- When you are comfortable with the installation positioning, attach the recorder bracket to
the windshield.
4)
Connect to power source to turn on the product
- Insert the cigarette lighter power adapter into an appropriate outlet.
If you start up the car or switch on the car ignition, the product will commence booting up.
- Blinking of LED lights indicates that the system has booted successfully.
- DO NOT turn off the power source while the system start-up is in progress as this
may cause damage to the product.
5)
Adjust the camera angle
