Important Safety Information
1.
Compressor: Use 12 volt DC only. Make sure that your vehicle 12V power socket is free of any ash,
residue or debris. A dirty power socket can cause the compressor and power cord to overheat.
Overheating can cause damage to your compressor/vehicle and could cause personal injury (disconnect
power when not in use).
2.
This air compressor is designed to inflate car tyres, bike tyres, ATV tyres, sports equipment, air
mattresses, beach toys and other inflatables. Do not use for any other purpose other than inflating.
If you do so, personal injury can occur.
3.
When operating your compressor do not run for more than 10 minutes of continuous use. Allow
compressor to cool down for 10 minutes before re-using.
4.
After using, turn off power switch (3).
5.
The compressor is not a toy. Keep away from
children at all times.
6.
Do not carry compressor by the air hose or
power cord, damage may occur.
7.
Do not leave the compressor unattended
while in operation.
8.
Do not over inflate. Be sure to follow the
manufactures instructions for the item you
are inflating.
9.
Keep the compressor away from flammable
areas/liquids at all times.
10. Do not operate the compressor in wet or damp areas.
11. Operate the compressor only with the accessories
that are included.
Your compressor is equipped with a Digital Tyre Pressure Gauge. The Pressure Gauge can be used to
monitor air pressure when filling your desired item, and can shut off the Compressor automatically
to the desired air pressure in your tyre or other desired items.
IMPORTANT INFORMATION ON THE OPERATION OR YOUR DIGITAL TYRE PRESSURE GAUGE
Your new Digital Tyre Pressure Gauge is capable of reading air pressure in the following formats:
PSI, Bar, KG/CM
2
or KPA. The gauge is defaulted at the factory in the PSI mode. If you desire to
change output mode from PSI to one of the other modes do the following:
1.
Connect the cigarette lighter to car power. Wait approximately 2 seconds for the gauge LCD display
to read 0.0.
2.
Press “R” button on the gauge to change the unit.
WARNING: Please do this only when the air hose is not connected to the tyres are this will cause an
incorrect reading.
3.
After selecting the mode, press “+” or “-” to set the pressure. It set on 35PSI from factory.
4.
When pumping, there is approximately 1 to 2 PSI difference between your tyre pressure and the
display figure due to the air hose back pressure.
5.
The digital gauge display will be subject to fluctuation while pumping.
6.
The digital gauge will automatically shut off in 15 seconds when the pressure is under 3 PSI.
12v
Digital AirCompressor
NOTE: THIS COMPRESSOR OPERATES ONLY ON 12 VOLT DC. DO NOT ATTEMPT TO OPERATE THIS
COMPRESSOR WITH ANY OTHER SOURCE OR VOLTAGE. DO NOT REWIRE OR RECONFIGURE
COMPRESSOR FROM IT'S ORIGINAL DESIGN OR PERSONAL INJURY OR BODILY HARM MAY OCCUR.
SWAC15
C
SWAC15-Manual-2018.qxp_Layout 1 25/07/2018 07:00 Page 2
