Im
1
2
3
4
5
6
7
8
9
1
1
Yo
m
to
IM
Y
P
c
1
2
W
3
4
5
6
1
4.
The gauge will display the current pressure (pressure reading tol or -3 P.S.I at 30 P.S.I)
5.
Press the Switch and the compressor will begin to operate. Inflate your tyre or desired item to the
correct pressure and shut off the compressor by pressing the Switch. CAUTION: Do Not Over Inflate!
6.
Disconnect the Valve Lock from the tyre and the 12 volt plug from the 12v power outlet.
To operate compressor/ gauge using the preset automatic shut off feature: (Operation A):
1.
Connect the 12 volt plug into 12v power outlet.
2.
If you wish to switch the unit of pressure measured, follow the steps 1 to 4 - IMPORTANT
INFORMATION ON THE OPERATION OF YOUR DIGITAL TYRE PRESSURE GAUGE on the front.
3.
The gauge is pre-set at the factory to 35 PSI. But you should press the “+” or (-) to start preset
function. You also can press the “+” or (-) to change the shut off pressure setting to the desired
automatic shut off pressure (Maximum: 150 PSI). Please do this only when the air hose is not
connected to the tyres as this will cause an incorrect reading.
4.
Connect the Valve/Tyre Chuck to tire air valve and push down the Valve Lock Lever to secure the
connection.
5.
The gauge will display the current tyre pressure ( pressure reading tol or – 3 P.S.I at 35 P.S.I)
6.
In the “preset” Mode the compressor will automatically shut off when it reaches the preset pressure
setting.
7.
Without preset the pressure, shut off the compressor when you are finished. CAUTION: Do Not Over
Inflate!
8.
Disconnect the Valve Lock from the tyre and the 12 volt plug from the 12v power outlet.
To inflate sport equipment:
1.
MATTRESS/RAFT (A OR B):
Insert the Mattress Adaptor into
the Valve/Tyre connector and push down the Lever to secure connection.
2.
Press Mattress/Raft’s Needle into Mattress/Raft Carefully.
1.
BALL (C):
Insert the Ball Adaptor into the Valve/Tyre connector
and push down the Valve Lock Lever secure connection.
2.
Press Adaptor’s Needle into Ball Carefully.
3.
Follow Compressor Operation steps A.
A
B
C
To operate compressor/gauge in normal fashion without preset function (Operation A):
1.
Connect the 12 volt plug into 12v power outlet.
2.
If you wish to switch the unit of pressure measured, follow the steps 1 to 4 at IMPORTANT
INFORMATION ON THE OPERATION OF YOUR DIGITAL TYRE PRESSURE GAUGE” on the front.
3.
Connect the Valve/ Tyre chuck to tyre air valve and push down the Valve Lock Lever to secure the
connection.
Streetwize Accessories:
Unit 1, Royce Trading Estate, Ashburton Road West,
Trafford Park, Manchester M17 1RY
Sales enquiries:
sales@streetwizeaccessories.com
Technical enquiries:
support@streetwizeaccessories.com
www.streetwizeaccessories.com
M17 1RY
SWAC15-Manual-2018.qxp_Layout 1 25/07/2018 07:00 Page 1
