1. Open Lid to fill.
5. Use On/Off trigger to
control spray.
6. Adjust Nozzle at end
for either Fine Mist or
Direct Spray.
2. Do not exceed maximum
filling level 8 Litres.
3. Pump handle to generate
pressure. Max 25 pumps.
7. Always release pressure
when job is finished, empty
the bottle of excess liquid.
Always wash thoroughly
after using chemical sprays.
General/Usage instructions for use.
Please note:
It is essential before using your
Power Washer
to ensure that
the Tab (A) is firmly secured
under the Lip (B), see diagram.
To secure, push down the handle
(if required) twist the Tab (A)
using the handle in the direction
of the arrow until it is fully
secured under the lip (B)
SWPW Instructions AW:Layout 1 19/4/13 15:36 Page 2
Streetwize Accessories:
Unit 1, Royce Trading Estate, Ashburton Road West, Trafford Park, Manchester M17 1RY
E-mail:
support@streetwizeaccessories.com
Telephone:
0161 447 8597 www.streetwizeaccessories.com
4. Safety pressure relief
valve will activate if max
pressure
is
reached.
It is recommended that this power sprayer is restricted in use to water-based
products and certain chemicals identified as harmful or irritant and/or carry
the labels above. When using paints, stains, pesticides and other water
soluble harmful substances, always observe the instructions and refer to
the Safety Data Sheets of the fluids that are being used.
ADVISORY WARNING: It is recommended that this equipment is NOT used for solvent paints, VOC’s and
chemicals hazardous to health.
This includes any chemicals
identified as Flammable, Oxidizing
Corrosive or Acutely Toxic and/or
which carry any of the symbols
shown opposite.
EU Registered address:
The Ace Supply Co (Europe) Ltd,
25 Herbert Place, Dublin 2, D02 A098 Republic of Ireland.
B
B
