6. Assembly and disassembly of the glass vessel of the "Smoothie" table mixer.**
- Insert the blade unit into the holder of the mixing bowl. Then place the seal on the blade unit and make
sure it fits snugly.
- Place the glass container holder with the inserted blade unit and the seal on the bottom of the glass
container and screw it to it.
- Insert the cap into the hole in the lid and turn it clockwise to fasten it. Then close the glass container with
the lid assembled in this way. In order for the lid to adhere well to the glass container, it is necessary to press
the lid thoroughly around its entire circumference.
- Mount the assembled glass container to the stand mixer.
- To remove the glass container, proceed in the opposite way.
APPLIANCE OPERATION
1. Using the attachments for mixing, whipping and kneading
- Select the attachment according to the purpose of use and assemble the appliance according to the
instructions given in the "Assembly" section.
- Put the ingredients in the container.
- Make sure that the multifunction head has been tilted to the horizontal working position and that the speed
control is set to OFF.
- Connect the device to the power supply.
- Set the required gear with the control knob. By continuously turning the control clockwise, the speed
increases, by turning it in the opposite direction, the speed decreases.
- For the initial mixing of the ingredients, first set the lowest speed and then adjust it as necessary.
- During operation, you can add ingredients to the container through the hole in the lid
- Pulse mode is used to increase the speed to the maximum for a short time.
- To activate the pulse mode, turn the speed control to position P.
- If it is necessary to wipe the ingredients off the walls of the container or from the attachment, first switch
off the stand mixer by setting the regulator to the OFF position and disconnect it from the mains socket. Wait
until the rotating parts have stopped before wiping the ingredients with a spatula.
- After use, set the controller to the OFF position and unplug the power cord.
- Wait until the rotating parts have stopped and remove the stand mixer.
- Use a squeegee to empty the contents of the container.
- After each use, clean the stand mixer according to the instructions in the "Cleaning and maintenance"
section.
2.
Using the meat grinder **
Meat grinding
- First prepare the meat for mincing as follows. Bone it, remove the tendons, cartilage and cut into pieces
measuring about 2 × 2 × 6 cm, which pass freely through the filling hole.
- Warning:
Do not process frozen meat. Let it defrost before grinding.
- Make sure that the stand mixer is correctly assembled and the controller is in the OFF position.
- Place a container for grounded meat under the grinder.
- Connect the mains plug to the wall socket.
- Set the required speed level with the control knob. We recommend setting a lower speed first and then
increasing it as needed.
- Insert the pieces of meat gradually into the filling hole.
- Never use your fingers, fork, knife, spoon, etc. during operation of the appliance to push food through the
filling hole Use a food slider for this purpose.
- Leftover meat left in the grinding chamber can be removed by grinding a slice of bread or croissant.
- To switch off the stand mixer, set the controller to the OFF position.
- After each use, clean the appliance according to the instructions in the "Cleaning and maintenance" section.
Summary of Contents for 801579
Page 44: ...4 24 4 4 24 4 roky ...
