Fig. 5
4. Test of hand pallet truck
4.1 After the truck is assembled, try to rock the hand grip and operate different positions of control handle
knob 1 to examine the lifting, free position and dropping and check that whether the different positions are
normal or not. See fig 5.
Fig. 5
4.2 The screw 53 in fig 4 is used to adjust the truck situation. When the truck body drops immediately after
it is lifted, you should turn the screw 53 a little counter-clockwise. And then try the truck again until truck
body could lift normally. If the truck body couldn’t drop after it is lifted, you sho
uld turn the screw 53 a
little clockwise. And then try to operate truck again until the truck body could drop normally. The external
hexagon nut 54 at screw 53 plays the locking function in the truck. So you should undo the external
hexagon nut before adjustment. And screw down the nut after you finish the adjustment.
5. Operation Manual
5.1 Before operation of the hand pallet truck please make sure that whether the cargo weight exceeds the
rated load or not.
5.2 The cargo loading type is shown as fig 6.
5.3 See fig5.1, when hand knob 1 is placed on the lift position, the truck will be in a state of lift. At this time,
if you rock the hand grip, the truck will be lifted.
5.4 See fig 5, when hand knob 1 is placed on the free position, the truck will travel. At this time, if you rock
the hand grip, the truck will neither lift nor drop. Then, you can use the truck to move the cargo.
5.5 See fig 5, when the hand knob 1 is placed on
the drop position, truck forks will drop. At this time, the truck forks will drop automatically.
5.6 See fig 5, when the hand knob 3 is placed blow, the truck will be in a state of free walking.
5.7 See fig 5, when the hand knob 3 is placed above, the truck will be in a state of brake.
5.8 See fig 5, hand knob 2 is used for release brake.
