38
Flashlight Operation
●
Press and hold
for 3 seconds to start
the flashlight.
●
Press
again to shift to SOS flashing.
●
Press
again to turn off the flashlight.
TROUBLESHOOTING
SAFETY INSTRUCTIONS
Problem
Cause
Solution
No response when press-
ing the push button.
The low voltage protection of
the Jump Starter is activated.
Charge the unit with a home
charger or car charger to
deactivate the protection.
The Jump Starter shuts
downautomatically when
charging multiple elec-
tronics devices at the
same time.
The over-current protection of
the Jump Starter is activated.
Charge the electronic devices
separately with different USB
outlets, but keep the total output
current within 3.5A.
READ
the user instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the
warranty.
Also, observe the safety instructions in the individual chapters of this
manual.
Make sure that the jumper cable clamps are always securely fastened to the battery terminals. If
the clamps are not attached properly, the jump starter will not be able to generate enough force to
jump start the battery
