27
USAGE
Charging the Battery of the Lights
❶
Lift the rubber cover to locate the USB charging port.
Note:
To charge the Tail Light, press down on the release latch to slide the Tail Light out. It is
unnecessary to disconnect the strap of the Tail Light from the bike to charge.
❷
Connect each light to the Micro USB connector of the charging cable. Connect the USB-A connector of
the charging cable with a USB adapter.
Only use a USB adapter 5V dc / (max.) 2.4A output (not included in the package) to charge the battery of
the lights. Charging with a power bank or using a USB port of a laptop/computer is allowed, but not
recommended.
❸
Unplug the USB charging cable when the LED indicator turns green or after 3 hours of charging.
Note:
The battery may be fully charged even if the LED indicator does not turn green.
LED INDICATOR DURING CHARGING:
Front Light:
The charging time from an empty battery to a full battery is about 3 hours.
●
Blinking red LED on the power button =
CHARGING
●
Solid green LED on the power button =
FULLY CHARGED
Tail Light:
The charging time from an empty battery to a full battery is about 1.5 hours.
●
Solid red LED on the power button =
CHARGING
●
Solid green LED on the power button =
FULLY CHARGED
LED INDICATOR LOW BATTERY WARNING:
During use, the bike lights will blink red to indicate a low battery situation. The bike lights will turn off within
minutes. Charge the battery again before use.
IMPORTANT:
Fully charge the battery of the Bike Light Set before the first time use.
WARNING:
●
Always follow the safety instruction as described in the chapter “SAFETY INSTRUCTIONS -
Battery Safety”.
●
Do not use or charge the bike lights if they are wet or damaged.
●
Do not use the bike lights while they are charging. Unplug the bike lights before use.
