38
①
First connect the red clip to the positive (plus) pole of the battery.
②
Connect now the black clip to the negative (minus) pole of the battery.
③
Once both clips are connected to the car battery, connect the Battery Charger to the power
supply.
④
Switch the power switch to “1” After the machine is turned on, it will automatically detect the
battery voltage and power, and flash the current battery power level.
WARNING:
WARNING:
Do not disconnect a charging clip wire during charging due to the danger
of sparking. First, remove the mains plug from the wall socket or wait
until the charge has been completed.
Once the charging is completed, for batteries permanently installed in
vehicles, follow these steps in the correct sequence:
1. Disconnect the Battery Charger from the mains.
2. Remove the negative charging clip (black) from the “-“ (negative) battery
terminal.
3. Remove the positive charging clip (red) from the “+“ (positive) battery
terminal.
4. Reconnect the vehicle’s positive connection cable to the positive battery
terminal.
5. 5) Reconnect the vehicle’s negative connection cable to the negative
battery terminal.