AUDACES
29
Figure6-12
2>
，
Adjust two side lines parameter in printing area
A>, adjust most left line. Make most left line straight by adjusting <Left
1>/<Left 2>/<Left 3>/<Left 4>/<Left 5>/<Left 6>/<Left 7>/<Left 8> value. As
below picture <Figure6-13>. Normally <Left 1> value keeps same, adjust <Left
2>/<Left 3>/<Left 4>/<Left 5>/<Left 6>/<Left 7>/<Left 8> value. If printing line
deviation left, you should increase value; if printing deviation right, you should
decrease value.
B>, adjust most right line. Make most right line straight by adjusting <Right
1>/< Right 2>/< Right 3>/< Right 4>< Right 5>/< Right 6>/< Right 7>< Right 8>
value. As below picture <Figure6-13>. Normally <Right 1> value keeps same,a
adjust < Right 2>/< Right 3>/< Right 4>< Right 5>/< Right 6>/< Right 7>< Right
8> value. If printing line deviation left, you should increase value; if printing line
deviation right, you should decrease value.
Figure6-13
4
，
Forward-and-backward deviation(Shown as following figure)
：
<Value of Step> is to adjust the forward-and-backward deviation of plotting.
Increasing the Value of Step will increase the interval between the paper
feedings during plotting. Reduce the Value of Step to reduce the interval
between the paper feedings during plotting.
Reduce the Value of Step in case there is clearance between the paper
feedings while plotting.
Clearance between paper feedings
Increase the Value of Step in case there are overlaps between the paper
feedings while plotting.
Overlaps between paper feedings
Summary of Contents for AUDACES Jet Lux Plus
Page 2: ...AUDACES 2...
