Operation
6 — 9
05_0186_0802GB
The tank pressure of machines without automatic mode must be
checked regularly during operation.
"
Check the tank pressure on the ”tank pressure” gauge.
Caution
The tank pressure must remain constant and should never fall below
5 bar.
Set the working pressure accordingly.
Interrupt operation as follows:
"
Stop the material flow.
"
Close the air valve on the spray gun.
⇒
The compressor switches off automatically.
Resume operation as follows:
"
Open the air valve on the spray gun again.
"
Start the material flow again.
⇒
The compressor switches on again automatically.
⇒
The spray gun is now ready for use again.
Stop delivery as follows:
"
Stop the material flow.
"
Close the air valve on the spray gun.
⇒
The compressor switches off automatically.
"
Switch off the machine. Refer also to chapter:
”Starting up” -- section: ”Shutting down the machine after
starting up”.
"
Carry out all steps described in the section on temporary
decommissioning. Refer also to chapter:
”Decommissioning” -- section: ”Temporary decommissioning”.
Interrupting operation
Resuming operation
Stopping delivery