Control Panel Identification
5
Mode
Mode key will change your spa - 3 different modes
1. Standard - Normal spa usage
2. Economy - Maintains temperature slightly lower than desired
3. Sleep - Keeps temperature approximately 20º below set temperature for inactive use
Mode is changed by pushing warm of cool keys with mode key.
Jet 1
Jet 1 controls pump 1 operation. Press firmly and then release, give time for system to
react. Pump operates in three different speeds.
1. Off if temperature is reached and filter is not engaged.
2. Low speed for filter mode. along with heating periods and any time customer prefers.
3. High when customer prefers, stays on only for 30 minutes at a time.
Jet 2
Jet 2 key controls pump 2. Operates on three (3) speeds. OFF- LOW - HIGH
Light
There are several color options in our spas and by pressing the light button in quick suc-
cession the customer can cycle through the different lighting options.
Warm
Press Warm to increase temperature. Once released, the controls will go back to the
current temperature display.
Cool
Press Cool to decrease temperature. Once released, the controls will go back to the cur-
rent temperature display.
Option
This key is not used to activate any operation in Strong spas.
BEFORE START UP! IMPORTANT UNION ADJUSTMENTS
There are SIX unions that require hand tightening prior to operation of your spa.
When filling the spa with water, keep observing these fittings for any slight water
drips. If a drip is observed, just hand tighten until dripping ceases.
