Customer Service 1•800•787•6649
11
Prepare for Your New Spa
L1
L2
GRND
Two Wire & Earth
(Also known as Ground)
These wires go to
the PC Board Control
Circuit.
Earth/Ground = Green & Yellow wire
L1 = Positive/Live = Brown wire
L2 = Negative/Neutral = Blue wire
230 Volt - Single service 1x16 - 20 AMP Breaker
230 Volt - Double service 1x32 - 40 AMP Breaker
Electrical Connections
Substitute these common
HOT
,
NEUTRAL
,
EARTH
GROUND
colors for your countries standard.
PLEASE CHECK YOUR LOCAL BUILDING CODES AND ONLY USE A CERTIFIED ELECTRICIAN TO
INSTALL ANY ELECTRICAL COMPONANTS TO YOUR SPA.
3-Phase Service, TN and TT Electrical
Systems
on 90 jet spa only
5 Wires (3 Lines + 1 N
1 Protective Earth)
Protective Earth wire 6mm
2
minimum
(Green/Yellow) must be connected to system
ground terminal as marked.
IMPORTANT - Service MUST include a neutral
wire, with a line to neutral voltage of 230VAC.
The heater runs on service line L1.
All main-board equipment run on service line L3.
Addtional equipment, such as expansion boards, run
on service line L2.
Completely remove the white wire from J26 and J32,
or J25.
Completely remove the blue wire from J28 and J58.
If an expansion board is installed, black wire must
connect to J28 (Line L2) only.
Systems using only 1 DIP switch (A10) for heat dis-
able:
• DIP Switch A10 must be OFF.
Systems using multiple DIP switches for heat dis-
able:
•Refer to Switchbank settings on inside cover of
pack.
Note: A residual current device with a tripping current rated not more than 30 mA
has to be installed in addition to local requirement.
Protective device for power connection must be on all phase conductors based on local requirements.
240V/50hZ 29 – 36 Amp draw, depending on model.
WARNING:
The electrical circuit must be installed by an electrical contrac-
tor and approved by a local building or electrical inspector.
Failure to comply with state and local codes may result in fire
or personal injury and will be the sole responsibility of the spa owner.
Improper installations present hazards which can result in personal
injury or property damage and void the warranty on the spa.
!
Summary of Contents for WK01S
