Customer Service 1•800•787•6649
23
Operate Your Spa
Pack Reset Instructions VS and GS Models
Tools:
Phillips head screwdriver, Needle nose pliers (optional)
First, turn the power off to the spa by using the breaker disconnect. Then, remove the cover to the pack
(electrical control unit inside spa). Locate the board diagram on the inside of the cover, and find J43 Persist-
ent Memory. This is located approximately ¾” above and ½” to the right the red dipswitch bank. It is a small
black piece of plastic located between two yellow pieces connected to the board. The jumper on J43 should
be hanging on one (1) pin and in a vertical position. Using needle nose pliers (or fingers) gently grab the black
jumper and remove from the board. Next, put the jumper back on the pin it came off of in the horizontal po-
sition using it to connect the adjacent pin. Proceed to turn the power back on to the spa. Once you see “PR”
on the top display, wait one (1) minute and turn the breaker back off. Now reverse the process. Take the
black jumper off of both pins and reposition vertically on just one pin (this is done just as a place-saver so
the jumper does not become lost). Replace the cover to the pack, and power the spa back on.
Pack Reset Instructions STREL Model
Tool:
Phillips head screwdriver
First, turn the power off to the spa by using the breaker disconnect. Then, remove the cover to the pack
(electrical control unit inside spa). Once the cover is removed, locate the board diagram on the inside of the
cover, and find the red dip switch bank. Using your screwdriver (or fingers) gently switch #12 (the one far-
thest from you) to the ON position (to the left). Proceed to turn the power back on to the spa. Once you
see “LINK” on the top display, wait one (1) minute and turn the breaker back off. Now reverse the process,
move dip switch #12 back to the off position (to the right). Replace the cover to the pack, and power the
spa back on.
Summary of Contents for WK01S
