-8-
T-C-CCN64AU17 © 2017 Simpson Strong-T
ie Company Inc.
LOADING THE TOOL
WARNING
•
Use only nails recommended by Simpson Strong-Tie for use in the CCN64 tool.
•
Disconnect air supply before loading and unloading.
•
Always handle the tool with care.
•
Never point the tool at yourself or another person.
•
Do not depress the nose of the tool or it will activate driving.
1. Hold the tool firmly
by the grip.
2. With the fastener length
selection pin at halfway,
depress tool against a
hard surface and slide
pin to relevant size of
nail intended to be used.
a. 1 ½
"
suits 38 mm
(± 2 mm) nails
b. 2 ½
"
suits 65 mm
(± 2 mm) nails
DO NOT OPERATE WITH
THE PIN AT HALF WAY
3. Hold the tool upside
down and insert a
strip of nails into the
corresponding size
slot at the rear of the
magazine with the point
of the nails facing the
nose area. Slide nails
all the way to the front
of the magazine.
4. Pull the pusher
to the rear of the
magazine until it is
engaged behind the
strip of nails (4a).
2.
2a.
3.
4a.
2b.
4.
1.