-10-
T-C-CCN64AU17 © 2017 Simpson Strong-T
ie Company Inc.
TOOL OPERATION
WARNING
•
Keep hands and body away from discharge area of the tool.
•
Never point the tool at yourself or others.
•
Use at 90-degree angle on clean dry surfaces.
•
The tool is activated by compressing the nose on on any surface or material.
•
The tool drives continuously while the nose is compressed.
•
The tool has no depth of drive adjustment and will overdrive unless
stopped by lifting the nose from the workpiece surface.
•
Be careful when fastening into dense woods and wood products.
•
Be careful to not drive a nail onto another nail.
•
When installing metal hardware, be careful that the
nail point is in the pre-punched hole.
•
If the tool becomes jammed and all nails cannot be removed
from the tool, the tool shall be removed from service.
12.
11.
9. Connect recommended
air supply.
10. The tools is
ready for use.
11. Locate hole in
connector. The
tool is activated by
compressing the nose
on the surface.
12. Depress the tool
continuously against
the surface at 90° until
the tool disengages
hammering.
10.
9.
