Strong SlimSat SA60, User Manual

2

PART 1 • English

1.0 WHAT IS T SA60?

SlimSat SA60 is a Horn Array Type Satellite Antenna with Dual Linear Polarization,
 it can receive signal from major Satellites and would replace a normal former 60cm Parabolic Dish.
Small, discreet and easy to use, it can be installed in a few minutes and used as a portable antenna for all 
satellite receptions.
SlimSat SA60 can be used for both free to Air and encrypted (requiring a subscription with an operator) 
channel reception; it can also receive all High Definition channels with a superior image quality.
For the use and installation, please read the following instructions and installation materials carefully.

2.0 SAFETY INSTRUCTIONS

n 

Before using this product please read this manual carefully and follow exactly all installation, 
mounting & orientation instructions.

n 

All the instructions should be followed in order to avoid any technical problems.

n 

Any electric or magnetic field close to the SlimSat SA60 may cause a bad reception or even cut 
off the signal completely.

n 

Do not drill the plastic cover of the antenna, which seals the antenna from moisture.

n 

Handle the antenna with care as any impact will cause damage to the electronics. 

n 

Do not open the cover, any attempt to repair by a non-qualified person can be dangerous and 
void the warranty.

n 

Any obstacle (buildings, trees, etc....) will block the reception of the signal from the satellite to the antenna.

n 

Do not paint or add any substance on the antenna cover, this will block the reception of the 
signal from the satellite.  

n 

The cable between the antenna and the Satellite receiver should not exceed 30m as it will 
decrease the quality of the signal.  

n 

The use non- isolated jacks will result in a loss of the signal level.

n 

For an optimum signal reception please use the Attenuation Thin Pad for the first installation. 
(for more details, please refer to chapter 

3.5

)

n 

Do not forget to adjust the antenna and the bracket to the cross-polarity (skew angle please refer 
to chapter 

3.4

 step 4).

n 

Tighten all the screws of the antenna once you have finished the adjustments.  

n 

This product contains one universal LNB, it is forbidden to add, change or modify the LNB.  

n 

For more precise details on the above points or for any information, please ask your retailer or 
customer service.

Warning!!!

 Antennas improperly installed to an inadequate structure are very susceptible to wind damage.  
This Damage can be very serious or even life threatening. The owner and installer assumes full 
responsibility that the installation is structurally sound to support all loads (weight, wind & ice)  
and properly sealed against leaks. The manufacturer will not accept liability for any damage  

caused by a satellite system due to the many unknown variable applications.