PART 1 • English
5
English
2.0 YOUR RECEIVER
2.1 Front Panel
see Fig.1
1. Mode indicator
The light indicates that the receiver is in STAND-BY mode. The
GREEN
light indicates
that the receiver is in AWAKE mode.
2. Power On/Off button
3. Channel Up/Down buttons
4. 4 digits display
In STAND-BY mode this indicates current time
In AWAKE mode this indicates current channel number
2.2 Rear Panel
see Fig.2
1. SAT IN
Connect the digital signal from your LNB on the satellite dish to this connector.
2. SAT OUT
Gives you the possibility to connect an extra receiver (analogue or digital).
3. ANT IN
To connect your aerial antenna or cable TV using coaxial cable.
4. TO TV
If you do not use a SCART cable to connect your receiver to your TV, or if you have
connected a cable to the ANT input, you will have to use this connector to connect the
receiver to your TV by using a coaxial cable.
5. TV SCART Connector
To connect your receiver to your TV set using a SCART cable.
6 . VCR SCART Connector
To connect your receiver to your video recorder using a scart cable. Your video signal will
now be looped through your receiver to your TV set.
7. S/PDIF Digital audio output
Use this coaxial output to connect your receiver to the input of your digital audio amplifier.
8. Audio Left/Right RCA Connector
To connect your receiver to your TV set or amplifier using RCA cable
9. Video RCA Connector
To connect your receiver to your TV set using RCA cable
10. RS-232 Serial Port
This serial port can be used to connect your PC with your receiver, to download new
versions of software to your receiver.
11. Power ON/OFF Switch
12. Power Cord
Your receiver requires a current of 90 ~ 240 V AC (Auto-selectable), 50 ~ 60 Hz +/-5%. Make
sure to check the power specification before connecting your receiver to the wall outlet.
