English
Troubleshooting
There may be various reasons for the abnormal operation of the unit. Therefore, if the unit
does not work properly, check it according to the procedures shown in the table below:
Remedy
Connect the power cord properly
into the power socket.
Connect the two terminals correctly
with RCA or RF cable(s), HDMI
cable(s).
Connect the antenna cable
correctly.
Adjust the direction of the antenna.
Check the cable connections
Type the setting values correctly.
Use a TV of the same mode.
Connect a NTSC/PAL converter
between the receiver and the TV.
Change the batteries.
Switch off the light.
Aim the remote control at the
receiver.
Check mains supply and ensure
that the unit is witched on both at
the mains and at the power switch
on the rear of the receiver.
Possible causes
The AC power cord is
disconnected.
Wrong connection of the
video/audio output to the
TV input terminal.
Wrong connection of the
terrestrial cable.
No signal or weak signal.
Wrong setting of channel
information in the MENU
screen.
Your TV mode (PAL/NTSC)
is different from the
terrestrial broadcasting
mode.
Batteries are exhausted.
Fluorescent light is
interfering with the remote
controller.
Remote controller is
incorrectly aimed.
No Power or Switched off.
Problem
The LED light on the front
panel does not light
No Picture or sound.
Black-and-white
screen or V-Hold.
The remote controller is
not working.
Unit will not operate.
6.10 PIP Function(Picture in Picture)
Ү
PIP is the feature where one program (channel) is displayed on the main screen at
the same time as another program (channel) is displayed in a smaller inset window
Ү
To activate the PIP function press the
PIP
button
Ү
This will bring a up Sub Channel List. From this list select the channel you wish to be
displayed in the PIP window by pressing the
button. Press the
button again to
remove the Sub Channel List
Ү
To change the channel displayed in the PIP window press the
PIP+
button to change
the channel up, or press the
PIP-
button to change the channel down.
Ү
To decrease the size of the PIP window press the
PIP
button
Ү
To remove the PIP window (if window is at largest size) press the
PIP
button twice
Ү
To remove the PIP window (if window is at the reduced size) press the
PIP
key once
Ү
To switch between the main channel and the PIP channel press the
PIP Swap
button
57
58
