Strong SRT 8203, User Manual

5

English

English

WARNING

!  

 The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries. If rechargeable 
accumulators instead of batteries are going to be used (e.g. NiMH), we 
recommend using types with low self-discharge to ensure long time 
operation of your remote control.

1.4 Usage of external USB devices

„

„

It is recommended to use USB 2.0 storage devices or higher. If your device is not compatible 

to USB 2.0 specifications, recording, playback and other multimedia functions of the receiver 

might not work properly.

„

„

STRONG cannot guarantee compatibility with all types of USB storage devices.

„

„

If you are going to use external USB HDDs (Hard Disk Drives), please consider that power 

specifications may exceed the supported output of your receiver (max. 5 V/500 mA). If so, 

please connect your USB HDD to an according external power adapter.

„

„

It is advised not to store important information on USB storage devices used with the 

receiver. Always make backups of data on your USB storage device before using it with this 

receiver. STRONG will not take responsibility for any loss of information or circumstances 

caused by loss of information.

2.0 YOUR RECEIVER

2.1 DEFAULT PIN: 0000
2.2 Front Panel

Fig. 1

1. 

Remote control sensor:

 Receives the signal from the remote control. Point your RCU towards this 

sensor

2. 

Mode indicator:

 RED indicates that the receiver is in STANDBY mode.

 GREEN indicates that the receiver is in OPERATING mode

3. 

USB:

Connector for USB storage and other devices.

2.3 Rear Panel

Fig. 2

1. 

ANT IN:

To connect to your antenna for reception of broadcasted signals.

2. 

IR:

To connect IR sensor extender.

3. 

HDMI:

Connect to TV set HDMI input.

4. 

AV:

Connect to TV set video and audio inputs.

5. 

DC IN:

 To connect power adaptor supplied with the receiver. (5 V, 1.2 A). Please, use 

only original adapter.

2.4 Remote Control Unit (RCU)

Fig. 3

1. 

q

Switches the receiver On/Standby

2. 

!

Mutes all audio outputs of the receiver

3. 

EPG

Opens the EPG (Electronic Programme Guide) in TV mode

4. 

INFO

 Shows information of the current programme. 2x opens the current event 

information and the signal information

5. 

TEXT

Displays Teletext contents

6. 

AUDIO

Select an audio language or audio mode