Strong SRT 8526, User Manual

PART 2 • English

10

To choose an event for watching, press 

ok

 to open the timer settings. The detailed timer setup is 

described in chapter 

6.4.1

.

After the timer has been set up, press 

ExIT

 to return to the EPG. To close the EPG, press 

ExIT

 again.

noTE:

Event information will be displayed when available. Availability depends 
on the broadcast.

5.5 selecting subtitle language

Press 

sUb

 in viewing mode to display a list of available subtitle languages. Use 

pq

 to select a 

language and confirm with 

ok

. Please consider that this function supports DVB and TXT subtitles 

and this selection is only displaying them temporarily. Subtitles may not be supported by every 
channel/broadcaster. Additionally please adjust your preferred subtitle language as described in 
chapter 

6.3.1

 Language Setting.

5.6 Displaying Teletext

To open the Teletext, press the 

gREEn

 (

TExT

) button in viewing mode. Use the 

0-9

 buttons to 

enter the page number. The coloured buttons allow you to jump directly to the pages as indicated 
in the bottom line. You can also use the 

pq

 buttons to select the next/previous page. With the 

tu

buttons you can select subpages. Press 

ExIT

 to close the Teletext.

5.7 Using external Usb storage devices

We strongly recommend you to carefully read and follow the specified points mentioned in chapter 

1.5

 Usage of external USB devices!

Further please consider these points when you use your receiver with an external USB storage 
device:

„

„

Before you disconnect the USB device from the receiver, we recommend using the 

Remove the USB device

 function which is available in several menus of your receiver. If you 

have removed the USB device unintentionally, then please reconnect it to be detected 
again.

„

„

Well functioning recording and playback is highly depending on the data rate supported 
by the connected USB device. Especially for recording and playback of video files as well 
as loading high resolution pictures, a reading speed of min. 10 - 15 MB/sec is required. As 
high data rates are not supported by all types of USB devices it is necessary to ensure that 
the used USB device can fulfil this requirement. Mostly such data can be found on the 
website or specification sheet of the USB device manufacturer. PC Software to measure 
the read/write speed of USB devices can be found via the internet as well, as an example 
“HD tune” can be used.

5.8 Instant Recording

Your new receiver allows you to make an instant recording of programmes you are watching. Simply 
press 

4

 to start the recording. To enter the duration for the recording, press 

4

 again.

Use 

0~9

 to input the recording time. For a recording duration of 45 min, just enter 45 and press 

ok

or for 1h 30 min, just enter 130 and press 

ok

. During the recording a progress banner appears on 

the upper left corner of your TV screen.
To open the recording info press 

I

. To stop the recording, press 

3

.

*Please connect a USB storage device formatted in FAT32 with sufficient free space before you start a recording. For recording HD broadcast, we strongly recommend to use a high speed device.

WARnIng:

 Within Irdeto encrypted services some events may be protected or limited 
and following to that recording might not be possible. This might also be 
the case for recording through the analogue output on Scart to a VCR or 
DVD recorder. If maturity rating is activated for a specific recording you 
will have to enter the appropriate PIN Code MATURITY Rating PIN: 0000 to 
record this event.