Strong SRT 8526, User Manual

PART 2 • English

3

English

safety Precautions

„

„

Never open the receiver cover. It is dangerous to touch the inside of the receiver due 
to high voltages. Opening the receiver will void the warranty of the product. Refer all 
maintenance or servicing to suitably qualified personnel.

„

„

When you are connecting cables, be sure that the receiver is disconnected from the 
mains supply voltage. Wait a few seconds after switching off the receiver before you 
move the receiver or disconnect any equipment.

„

„

It is a necessity that you only use an approved extension and compatible wiring that 
is suitable for the electrical power consumption of the installed equipment. Please 
ensure that the electrical power supply corresponds with the voltage on the electrical 
identification plate at the back of the receiver.

If the receiver does not operate normally, even after strictly following the instructions in this user 
manual, it is recommended to consult your local dealer or contact the appropriate service.

1.2 storage

Your receiver and its accessories are stored and delivered in a packaging designed to protect 
against electric shocks and moisture. When unpacking it, make sure that all the parts are included 
and keep the packaging away from children. When transporting the receiver from one place to 
another or if you are returning it under warranty conditions, make sure to repack the receiver in its 
original packaging with its accessories. Failing to comply with such packaging procedures could 
damage the product and void your warranty.

1.3 Equipment set-up

We recommend you consult a professional installer to set up your equipment. Otherwise, please 
follow the instructions below:

„

„

Refer to the user manual of your TV and your antenna.

„

„

Make sure that all the connections, cables and outdoor components are in a good 
condition and all the connections are well shielded and from good quality. We 
recommend using high quality HDMI cables at least corresponding to HDMI 1.3 standard.

This manual provides complete instructions for installing and using this receiver. The following 
symbols will serve as follow:

WARnIng:

Indicates warning information.

noTE:

Indicates any other additional important or helpful information.

mEnU

Represents a button on the remote control or the receiver.

(

bold Characters

)

Move to

Represents a menu item within a window.

(

Italic Characters

)

1.4 Accessories

„

„

Receiver - 1 pc.

„

„

User Manual - 1 pc.

„

„

Remote control - 1 pc.

„

„

Batteries (AAA) - 2 pcs.

WARnIng:

The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries.

If rechargeable accumulators instead of batteries are going to be used, we recommend using (e.g. 
NiMH) types with low self-discharge to ensure long time operation of remote control.