background image

ELECTRIC WINCH RATING*

  

5% 

10% 

20% 

30% 

50% 

70%  

   (3°) 

(6°) 

(11°) 

(17°) 

(26°) 

(35°) 

 

 

10,000 lbs.   7,500 lbs.  5,100 lbs.  3,900 lbs.  2,700 lbs.  2,200 lbs.  1500 lbs. 

   4,536 kg  3,402 kg  2,313 kg  1,769 kg  1,225 kg  998 kg 

681 kg

 

 

14,600 lbs. 11,000 lbs.  7,400 lbs.  5,700 lbs.  4,000 lbs.  3,300 lbs.  2200 lbs.

 

   6,623 

kg

  4,990 

kg

  3,357 

kg

  2,586 

kg

  1,814 

kg

  1,497 

kg

 

999 

kg

 

 

20,000 lbs. 15,000 lbs. 10,200 lbs.  7,700 lbs.  5,500 lbs.  4,500 lbs.  3,000 lbs. 

  9,072 kg  6,804 kg  4,627 kg  3,493 kg  2,495 kg  2,041 kg  1,362 kg

 

 

30,000 lbs.   22,600 lbs. 15,200 lbs. 11,600 lbs.  8,300 lbs.  6,800 lbs.  4,500 lbs. 

  13,608 kg  10,251 kg  6,895 kg  5,262 kg  3,765 kg  3,084 kg 

2,043 kg

12 Volt DC 

ELECTRIC WINCHES

       

WARNING: 

READ INSTRUCTIONS CAREFULLY BEFORE 

ATTEMPTING TO INSTALL, OPERATE OR SERVICE THE STRONGARM  

ELECTRIC WINCH. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT 

IN SERIOUS OR FATAL INJURY. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.

DOUBLE LINE OPERATION

Models SA7000, SA7015, SA12000 and SA12015 

are factory equipped with a pulley block and hook 

and 50' of cable for double line operation. This 

increases the pulling capacity of the winch as 

shown, however, care must be taken to allow ade-

quate motor cooling. Note that with double line, a 

pull of 25' requires reeling in 50' of cable.
For intermittent use only. Ratings at left are based 

on 10' pull. For longer pulls motor cooling periods 

must be allowed.

MAXIMUM CONTINUOUS RUN TIME 4 MINUTES

 

CAUTION: CONTINUOUS RUNNING IN 

EXCESS OF 4 MINUTES WILL DAMAGE WINCH 

MOTOR.

GUIDE TO ROLLING LOAD CAPACITY**

Maximum weight in pounds and kilograms rolling load.

APPROXIMATE LOAD 

SPEED 

(FT./MIN.)

 

MODEL

 

 PERCENT INCLINE

LOAD

CAPACITY

(*)  Load capacity (dead weight) is a measure of actual maximum force to which the 

winch system may be subjected.

(**)  All capacities shown are with 15' of cable on the reel and 10% rolling friction factor. 

For full reel of cable adjust capacities according to graph above. Note 5% incline is 

one-half foot rise in ten feet.

WINCH RATINGS

OWNER’S 

MANUAL

MODELS SA5000, SA5015, SA7000, SA7015,

SA9000, SA9015, SA12000, SA12015 

5000
4500
4000
3500
3000
2500
2000
1500
1000

500

DEAD WEIGHT CAPACITY (LBS.)*

LENGTH OF CABLE ON REEL (FT.)

10  

20  

30  

40   50

SA9000 & SA9015 single line

SA12000 & SA12015 double line

SA7000 & SA7015 double line

SA5000 & SA5015 single line

 

WARNING: NOT TO BE 

 

USED AS A HOIST FOR 

LIFTING, SUPPORTING OR 

TRANSPORTING PEOPLE OR 

LOADS OVER AREAS WHERE 

PEOPLE COULD BE PRESENT!

E

N
G

L

I

S

H

F

R

A
N

Ç

A

I

S

1

F

R

A
N

Ç

A

I

S

®

Form No. 206342L 11/20

© 2020 CORNHUSKER PRESS

Code daté du treuil:

 

(Situé à l'intérieur du cadre au dos)

Numéro du modèle de treuil:
Date d'acquisition:

NOTES

DÉCLARATION DE CONFORMITÉ

 - Dutton-Lainson Company, Hastings, NE 68902-0729 U.S.A. construit le treuil mentionné 

ci-dessus et déclare qu’il répond à toutes les dispositions applicables de la Directive 2006/42/CE.  Le dossier technique 

peut être obtenu auprès des personnes indiquées ci-dessous.

Hastings, NE USA
November 30, 2020

Director of Engineering
Dutton-Lainson Company

Jack Singleton
Eurowarehouse BV
De Amstel 11
8253PC Dronten
The Netherlands

SA5000

SA5015

SA7000

SA7015

SA9000

SA9015

SA12000

SA12015

 

NO LOAD  FULL LOAD

 

Full  Empty  Full  Empty

 

Reel  Reel  Reel  Reel

 

33 

12 

4

 

16 

4.5  3.5

 

11 

2.5

 

2.5 

1.5

SA5000

SA5015
SA7000

SA7015

SA9000

SA9015
SA12000

SA12015

Summary of Contents for SA5015









Reviews: