4
ASSEMBLY INSTRUCTIONS
1. Install ratchet bar into frame (fig.1) with ratchet portion of bar aligned with locking pawl
(stopper).
2. Move the ratchet bar to its lowest position by raising the locking handle, thereby releasing the
stopper, and guiding the bar downward (fig. 2).
3. Bend metal tab in (Fig. 3) using a hammer and punch.
4. This will help prevent inadvertent separation of the ratchet bar from base frame.
OPERATING INSTRUCTIONS
1. Adjust height by pulling up on ratchet bar.
2. The weight of the locking handle should secure the ratchet bar in desired position. To confirm
this, simply push down on the locking handle. Check to ensure ratchet is secure before loading.
3.
Carefully position jack stands so that load is centered on stand’s saddle.
4.
Slowly
lower the vehicle onto the stands.
5. Check to ensure vehicle is secure before working on, around or under. When used to support
vehicle, use wheel chocks on all unlifted wheels in both directions to prevent inadvertent
movement.
TO LOWER LOAD
1. Ensure that all tools, equipment and personnel are clear before lowering load.
2. With suitable jack, raise vehicle clear of stands.
3. Carefully release stopper and allow ratchet to glide down to lowest position.
4. Carefully remove stands, then carefully lower vehicle with lift device.
MAINTENANCE
•
Maintain your jack stands.
It is recommended that the general condition of any
jack stands
be
examined before they are used. Keep your
jack stands
in good repair by adopting a program of
conscientious repair and maintenance. Have necessary repairs made by qualified service
personnel.
•
Periodically inspect each stand.
Ensure all parts move freely. Do not apply oil or grease to
any portion of this product. If rust appears, sand affected area and cover with suitable utility
paint. Please note that there are no replacement parts applicable to this device.
STORAGE
Store stands in upright position and in a clean, dry area.
