Page of 8
5
5. Attach the Seat to the Seat Post with Four 10*15 mm bolts, washers and nuts. Use a pliers
and a flat head screwdriver to fully tighten the bolts in place. Note that the threaded stem of
the Seat Post has a Washer and Cotter Pin pre-installed. Check by looking under the Seat
to make sure the Cotter Pin is wrapped around the shaft and secure (Fig.5).
The Seat may be raised or lowered to a desired height simply by turning it clockwise or
counterclockwise. We recommend adjusting the Seat to a height where your feet rest level
on the ground.
Fig.4
Fig.5